Page 2 of 8
Re: Speed - mm/minute? Why not mm/sec?
Posted: Tue Mar 04, 2014 3:03 pm
by davedfx
+1 user switchable
Re: Speed - mm/minute? Why not mm/sec?
Posted: Tue Mar 04, 2014 7:59 pm
by jd_3d
+1
Re: Speed - mm/minute? Why not mm/sec?
Posted: Sat Mar 08, 2014 9:18 pm
by timbologist
+1 USER SWITCHABLE
Re: Speed - mm/minute? Why not mm/sec?
Posted: Sun Mar 09, 2014 3:15 pm
by rsilvers
Or both next to each other, and if you change either value, the other updates.
Re: Speed - mm/minute? Why not mm/sec?
Posted: Mon Mar 10, 2014 10:15 am
by nancy
+1 -- I prefer mm/sec. If you made it user switchable that'd be awesome, but I doubt I'd use the mm/minute settings much.
Re: Speed - mm/minute? Why not mm/sec?
Posted: Tue Mar 11, 2014 7:35 am
by dubtec
agreed, either default or choice in settings... thanks
Re: Speed - mm/minute? Why not mm/sec?
Posted: Mon Mar 24, 2014 1:59 am
by Flateric
+1
Re: Speed - mm/minute? Why not mm/sec?
Posted: Mon Mar 24, 2014 9:45 am
by Don
I was wondering if it was just me that thought that was odd. I'm not alone!
Re: Speed - mm/minute? Why not mm/sec?
Posted: Wed Mar 26, 2014 5:43 am
by joesoap583
+1
Re: Speed - mm/minute? Why not mm/sec?
Posted: Fri Mar 28, 2014 10:07 am
by CatDog
New user here (1 week) and as I make my way up the unfortunately steep learning curve, it is implementations like this (and there are many others I will be posting about) that make me wonder if the developer has actually ever done any 3D printing. As a professional software developer specializing in usability, I am discouraged and disappointed by S3D's apparent lack of understanding of its users. 1 hour with a group of users and a paper prototype would have made the product much more usable. I still can't figure out how to get my printer configuration to "stick" - every time I close S3D it disappears and I have to configure again.
~CatDog>