Page 2 of 4
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Sun May 04, 2014 9:02 am
by ItchyPigCreations
+ 1
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Tue May 06, 2014 10:42 pm
by twidget
+1
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Mon May 12, 2014 12:22 pm
by Umpa
I was looking for this too, I can't believe you can't change it.
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Sat May 17, 2014 5:19 pm
by marcnicol
+1 please
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Tue Jun 17, 2014 2:33 pm
by paeonius
any follow ups?
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Tue Jun 17, 2014 9:38 pm
by jimc
well we have not seen a new release since this topic started so when the next update hits we will see.
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Thu Jun 19, 2014 11:16 am
by TenKOhms
Hi, I have found this feature under process settings > other tab. Hope that helps.
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Thu Jun 19, 2014 12:17 pm
by pdegior
Like everyone else I was trying to figure this out too. I don't have that field in the screenshot you uploaded. I noticed you are using the mac version. I am using the windows version so perhaps this was missed for us in this release.
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Thu Jun 19, 2014 1:07 pm
by AndersE
TenKohm's:
Ehh that is not in windows version 2.1.0. If it had, then i think everybody had found it by now.
And that quick set of plastic type i haven't seen in a while. Always wondered where it had gone.
Edit: now that i check again, the plastic type / quality selection is only present on the presets for other machines..WHY?
Re: V2.1: Where do you set filament Cost and Currency?
Posted: Thu Jun 19, 2014 1:36 pm
by TenKOhms
AndersE wrote:TenKohm's:
Ehh that is not in windows version 2.1.0. If it had, then i think everybody had found it by now.
And that quick set of plastic type i haven't seen in a while. Always wondered where it had gone.
Edit: now that i check again, the plastic type / quality selection is only present on the presets for other machines..WHY?
I have it working on my windows partition as well... try updating? I'm not sure what version is running on my windows side, but I installed it a few hours ago and saw the feature there as well