Simplify3D User Forum

Has this been confirmed to work with the 1.10 firmware update? Thanks!

Hi

Yes, i work with Firmware V1.10 / V2

Andy

Hi

Does anyone have a working PLA Profile?

Andy

Hi,

use Profil CubePro_Ex2.fff from -Michaelherron- and Change Extruder Temp. to 195C and the 2. Temp to 60C.
It works on our Cubepro duo

hi tom

i have modified the profile with changed the extruder to ex1, and change the filament in extruder 1 to pla ).
but now the printer heats up the chamber like with abs. but with pla thats not so good

do you know where i can disable the heater for the chamber?

thx,

andy

Hi Andi,

I don´t know how we stop the chamber, I take the top cover away and open the frontdoor

Tom

Hi Andy,

delete in Cubepro_Ex2.fff in Scripts M404 and the Chamber is off

Tom

hi tom

thank you, that was it

the heater is now off!
but i have two more problems which i have to solv.
the pla does not stick ( even with glue ) good on the bad and peal off at bigger prints.
the extruder "clacks" during prints with PLA (not with ABS, ABS works fine ), i think they extrude a bit to much fillament.
so i do some more test....

andy

Hello all...

I tried a print on our CubePro Trio but the printer just seem to hang at the "heating up the chamber" step and never starts printing. The little bar graph never seems to get all the way to right side.

This does not happen when sending a .cubepro file that was created by the CubePro software.

Any thoughts?

Thanks
CB

now my printjob ( 12hr ) is finally done

i covered the cubepro printbed with blue paintertape and level the paltecarefully.
now the pla sticks very well to the printbed.
with the profile the first layer i think it a bit too much extrusion, because the pully snaps over.
but after thirt layer its seems ok...

andy