Re: Marlin firmware on GEN6 electronics
Posted: Mon Apr 08, 2013 5:13 pm
by Lateralg
Yep. Set at 4 & 6. No change.
FWIW the present situation is Pronterface says "connecting ..." and build area of screen flashes about every 2 seconds.
Re: Marlin firmware on GEN6 electronics
Posted: Mon Apr 08, 2013 6:57 pm
by Lateralg
The plot thickens:
Pronterface (printrun?) log has the following entry ... for each time I try to connect.
Traceback (most recent call last):
File "pronterface.py", line 1566, in connect
File "printcore.pyc", line 76, in connect
File "serial\serialwin32.pyc", line 30, in __init__
File "serial\serialutil.pyc", line 260, in __init__
File "serial\serialwin32.pyc", line 56, in open
serial.serialutil.SerialException: could not open port COM2: [Error 2] The system cannot find the file specified.
Correcting this is beyond my knowledge. Can someone help?