Page 3 of 5
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Wed Jan 13, 2016 10:13 am
by garyl
Yes +1 The zig zag in thin walls is bad for the printer and your prints.
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Sun Jan 24, 2016 3:35 am
by pipaev
+1
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Tue Jan 26, 2016 4:09 am
by sonderzug
+1 !
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Tue Jan 26, 2016 10:58 am
by mroek
+1
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Tue Jan 26, 2016 5:14 pm
by Alex Borro
A great feature that S3D still lacks..
Cheers.
Alex.
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Wed Mar 16, 2016 2:59 am
by highground
+1!!!
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Sat May 07, 2016 1:08 am
by highground
3 pages of support for this request guys, can we at least get a comment? The free software can do it....
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Mon May 09, 2016 9:09 am
by McSquid
+1
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Mon May 09, 2016 10:44 am
by Joshb60796
+1! not to mention if you have wiping turned on, simplify3d wants to wipe in the zigzag pattern and it messes up the print quality drastically.
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Posted: Tue May 10, 2016 6:59 am
by CompoundCarl
Joshb60796 wrote: if you have wiping turned on, simplify3d wants to wipe in the zigzag pattern and it messes up the print quality drastically.
Just go to the Advanced tab an enable "Only wipe extruder for outer-most outlines". Then it only uses wiping on the outer-most perimeter and not on any of the zig-zag internal fill. Works fine for me.