Re: Variable Layer Height Algorithm
Posted: Tue Jul 25, 2017 11:20 pm
+1!!!
Simplify3D User Forum
Simplifying the 3D Experience!
https://forum.simplify3d.com/
Variable Layer Height Algorithm
Page 3 of 3
Re: Variable Layer Height Algorithm
Posted: Wed Jul 26, 2017 9:28 pm
+1. The free slicers have had this for some time now.
Re: Variable Layer Height Algorithm
Posted: Tue Aug 01, 2017 5:44 am
The hope is gone now - V4.0 does not provide variable layer height 
@Simplify3D team: ist this feature on your plans?
@Simplify3D team: ist this feature on your plans?
Re: Variable Layer Height Algorithm
Posted: Tue Aug 01, 2017 1:52 pm
Re: Variable Layer Height Algorithm
Posted: Wed Aug 02, 2017 10:52 am
+1
take a look at the slic3r prusa edition where it is integrated perfectly with smooth transistions!
take a look at the slic3r prusa edition where it is integrated perfectly with smooth transistions!
Re: Variable Layer Height Algorithm
Posted: Thu Aug 03, 2017 5:22 pm
I am *blown away* that this has not yet been implemented in what is supposed to be considered a "premium" slicer.
The variable settings wizard is far less useful, and only barely catches up to where Slic3r quite some time ago.
This is the #1 feature that I was hoping would make it into 4.0, and I am sorely disappointed that it has not been implemented.
The variable settings wizard is far less useful, and only barely catches up to where Slic3r quite some time ago.
This is the #1 feature that I was hoping would make it into 4.0, and I am sorely disappointed that it has not been implemented.
Re: Variable Layer Height Algorithm
Posted: Tue Aug 08, 2017 7:30 am
The variable settings are nice, but this would be fantastic. Maybe even if it was just an automatic variable settings/process split based on the details each process would have their respective layer heights. Just embellish on the variable settings and make an "auto variable settings" or "suggested variable settings" ? Maybe this could be quicker/easier to implement?