Page 4 of 4
Re: Monotonic Top/Bottom infill
Posted: Tue Feb 28, 2023 9:26 am
by SteveGamer7
+1. Yes please. It would make 'show pieces' better looking.
Re: Monotonic Top/Bottom infill
Posted: Sat Mar 04, 2023 4:57 am
by itbartie
Latest Simplify3D Version 5.0.2 and still no Monotonic infill!!!
Why is this request so hard?
Wish I hadn't wasted my money on this supposed new Version 5.
SuperSlicer is so much better.
Re: Monotonic Top/Bottom infill
Posted: Fri Mar 24, 2023 10:48 pm
by gearsawe
+0.5 nice to have. did not even know this was a thing. just an odd term Monotonic... mono-directional fill maybe?
Re: Monotonic Top/Bottom infill
Posted: Wed May 03, 2023 10:46 am
by Moto'freak
+1 some of my prints look "fugly" on the top layer and had to use other software to get the job looking right!
Been using this software for a few weeks now and I actual regret buying it at the full "new" price, it does make a lot of things with ease, but only in draft quality on that top layer. I have to use other software to produce a quality finish that I can sell.
A frustrated new customer
Re: Monotonic Top/Bottom infill
Posted: Thu May 11, 2023 11:41 am
by S3D-Jason
Happy to say that Monotonic infill was implemented in our latest Version 5.1 release. We've seen some notable print quality improvements using the feature, so thank you to everyone that requested it!
You can see all of the other features in Version 5.1 here:
https://www.simplify3d.com/products/sim ... rsion-5-1/