Simplify3D User Forum

hi,
took the leap and purchased Simplify3D , love it , very slick.couple of questions >..
1. After rotating a part is there anyway to stop it sinking under the printbed other than dropping the part again and watching it bounce?
2. When you right click to change rotation etc, does the pop up screen always appear over the middle of the screen and covering the object your trying to manipulate?
3. is there any future possibility of options to mirror a part ?

love it so far though

Unfortunately I don't have answers, but on #2, I completely agree. Super annoying that the part ends up behind the window. I always end up moving it out of the way so I can see where the part goes.