Simplify3D User Forum

Hi,

I am new to Simplify3D. Maybe this is a problem with my settings. But my previous prints did work with the same settings.

You can see the parts here: http://www.plastikdrucker.de/drucker2/SimplifyK1_A.jpg

The slicer fills each hole inside the parts: http://www.plastikdrucker.de/drucker2/SimplifyK1_B.jpg

I have uploaded a factory file, just in case it helps: http://www.plastikdrucker.de/drucker2/Part1.factory

Is this a bug?

Best regards,
Andreas

It is not a bug. I checked by mistake the "Merge all outlines into a single solid model" option on the advanced tab.