FFF: creating filament-dependent quality settings
Posted: Wed Jun 06, 2018 11:18 am
Is it possible to create <autoConfigureQualityquality presets as subsets of autoConfigureMaterial presets in the FFF?
E.g. could I save bridging settings in the XML that depend on both the material and the layer height?
CitySlicker has explained that settings such as bridgingFanSpeed can only exist in the quality OR the filament settings, not both: viewtopic.php?t=9893
Can I nest one inside the other?
E.g. could I save bridging settings in the XML that depend on both the material and the layer height?
CitySlicker has explained that settings such as bridgingFanSpeed can only exist in the quality OR the filament settings, not both: viewtopic.php?t=9893
Can I nest one inside the other?