A different reason my print stopped - this is How I continued the print…
Total Estimated print time 8 hrs. During the second hour, the print stopped due to a thermistor coming loose from print head. This is how I continued the print (which, will also work for a power outage)…
(Note: I print from sdCard, not usb)
1). Measured distance from print-bed to the top of the partially printed part. Removed the part from printer.
2). In Simplify, changed the Z height (to bury the part below the bed the distance I measured.
3). Generated a new print gcode file and printed it.
4). Glued the two halves together.
Sure, some mated-edge and glue clean-up required but I intended to paint it anyway (using this approach https://www.youtube.com/watch?v=0vgynnY ... gs=pl%2Cwn
) and this saved two hours and 20 meters of Filament.