nickrummy
Posts: 1
Joined: Tue Jun 12, 2018 8:52 am

Process options not working?

Tue Jun 12, 2018 8:55 am

Hello,

I'm using a MakerGear M2 and it has worked flawlessly until someone else started using it a few weeks ago. Some things were changed and I can't figure out how to get it back to what it was.

I've setup my own process and have a few options like wipe nozzle and wait for the extruder and bed to get up to temp before printing but it doesn't do either of these things. When I go to print a part it will home itself and then just try to start printing without heating up, it's also ignoring the wipe nozzle option.

I've read about settings not saving unless you exit the program but nothing is helping. Any ideas? thank you!

Return to “Troubleshooting and Bug Reports”