Page 1 of 1
[SOLVED]horiz shrink missed a tooth on my gear
Posted: Sat Jun 23, 2018 5:05 pm
by mchahn
I have a gear with 8 teeth. I set the horizontal offset to -0.3. When rendered, one of the teeth did not have the shrink. This has worked many times before. See the before and after prints...
Re: horiz shrink missed a tooth on my gear
Posted: Sat Jun 23, 2018 6:12 pm
by dkightley
There must be something strange with your shape. The best thing would be to attach a factory file for this model to a post...then someone can have a look at what might be wrong.
Re: horiz shrink missed a tooth on my gear
Posted: Sun Jun 24, 2018 11:00 pm
by mchahn
I think I was mistaken. I guess it was shrunk but the model was screwed up. How do I close this topic?