electric-2000
Posts: 4
Joined: Fri Jun 27, 2014 1:54 am

Top Layer Print Angle Setting

Tue Aug 07, 2018 2:43 am

When printing single wall prints for my Radio Controlled models I often need to add top layers to open areas throughout the print. The problem is that I have walls that are angled at certain degrees where the slicer thinks it is at enough of an angle to consider it a "top" surface (see attachment).

Question- Is there a setting to tell the slicer a max angle to stop printing top layers?
Attachments
Top Layer Issue.JPG

electric-2000
Posts: 4
Joined: Fri Jun 27, 2014 1:54 am

Re: Top Layer Print Angle Setting

Sun Aug 12, 2018 12:04 am

Does anyone have any experience with following issue?

"Is there a setting to tell the slicer a max angle to stop printing top layers?"

TIA
-Mike

Return to “General Discussion and Tips”