First and Top Layer not filled
Posted: Wed Aug 29, 2018 10:12 am
Dear all,
I am new with 3D printing and I have a simple problem.
Attached this post you can find two Pictures. What can I set that the first and top Layer is complete filled? If you zoom into the pictures you can see that there are small gaps between the lines.
Regards
Stefan
I am new with 3D printing and I have a simple problem.
Attached this post you can find two Pictures. What can I set that the first and top Layer is complete filled? If you zoom into the pictures you can see that there are small gaps between the lines.
Regards
Stefan