Posts: 1
Joined: Tue Jun 03, 2014 3:04 pm

Second extruder offset

Hello to all!
I'm Marco from Italy, i need a little help for configure the software, my printer configuration is:

Delta printer (like Rostock)
Two head
Ramps 1.4
Repetier firmware (last version)

Heads offsets are configured in firmware, h1 -10.8,0.0 h2 10.8,0.0

I can print with repetier and cura without any problem, but with simplify3d i can't configure the right offset, please help me!!!

Posts: 34
Joined: Thu Mar 20, 2014 9:54 pm

Re: Second extruder offset

with repetier i set the offset in eeprom, then i just enable the second extruder in processes. if you type t0 and t1 in the command window you should see that it pulls offsets and applies them from eeprom

Return to “Troubleshooting and Bug Reports”