Page 1 of 2
No retractions between printed support and perimeter?
Posted: Sat Nov 10, 2018 8:25 am
by SweHogelid
Is it just me or does it no longer retract after printing support and starts to print perimeter or next solid layer?
Re: No retractions between printed support and perimeter?
Posted: Sat Nov 10, 2018 10:30 am
by Glasofruix
It's a bug, there's no retraction between layers even if you force it with the checkbox. It'll ooze filament across your print no matter what.
Re: No retractions between printed support and perimeter?
Posted: Mon Nov 12, 2018 11:19 am
by afshin
hi, you can simply solve that by turning on FORCE RETRACTION BETWEEN LAYERS on advanced tab
Re: No retractions between printed support and perimeter?
Posted: Mon Nov 12, 2018 12:20 pm
by S3D-Alex
Can you please post a Factory File for this?
Re: No retractions between printed support and perimeter?
Posted: Mon Nov 12, 2018 11:29 pm
by charliedrums
I'm Having the same issue. My printer is a Fusion3 F410. Here is the profile
Re: No retractions between printed support and perimeter?
Posted: Tue Nov 13, 2018 1:49 am
by SweHogelid
S3D-Alex wrote: ↑Mon Nov 12, 2018 12:20 pm
Can you please post a Factory File for this?
Sorry, dont have that factory file. I have the gcode if that would help?
I guess I could do a similar setup with that model but it was an 22hr print so I'm not very keen on printing it again.
Re: No retractions between printed support and perimeter?
Posted: Tue Nov 13, 2018 1:51 am
by SweHogelid
afshin wrote: ↑Mon Nov 12, 2018 11:19 am
hi, you can simply solve that by turning on FORCE RETRACTION BETWEEN LAYERS on advanced tab
That wouldn't solve anything as my problems aren't between layers, and enabling that introduces other problems I don't want.
Re: No retractions between printed support and perimeter?
Posted: Tue Nov 13, 2018 8:02 am
by charliedrums
Re: No retractions between printed support and perimeter?
Posted: Tue Nov 13, 2018 8:29 am
by charliedrums
Tried creating a new fff file from scratch and still have the same issue. Reverting back to 4.0.1 until the issue is resolved.
Re: No retractions between printed support and perimeter?
Posted: Wed Nov 14, 2018 12:55 pm
by S3D-Alex
SweHogelid wrote: ↑Tue Nov 13, 2018 1:49 am
S3D-Alex wrote: ↑Mon Nov 12, 2018 12:20 pm
Can you please post a Factory File for this?
Sorry, dont have that factory file. I have the gcode if that would help?
I guess I could do a similar setup with that model but it was an 22hr print so I'm not very keen on printing it again.
SweHogelid if you could post that gcode file it would be very helpful. I have been testing this trying to recreate your description but have been unable to make the retractions not occur when the option to Force Retraction Between Layers is turned on.