Page 1 of 1
Printer on your Supported List but not in Program
Posted: Sat Nov 10, 2018 9:41 pm
by LePaul
Myself and a few others have run into a rather annoying issue.
Using your website, it says you support the Geeetech A10 3D Printer.
Using the S3D Configuration Assistant, that printer is not on the list.
This is happening to other models as well.
Please fix.
Re: Printer on your Supported List but not in Program
Posted: Sun Nov 11, 2018 4:34 am
by Fladdie
Same here with Craftbot 3 printer
Re: Printer on your Supported List but not in Program
Posted: Mon Nov 12, 2018 8:29 am
by wirlybird
email then and usually they'll send you a profile.
Re: Printer on your Supported List but not in Program
Posted: Mon Nov 12, 2018 1:14 pm
by Killeruwi
The FLSUN printer models are also not available in the drop-down list
Re: Printer on your Supported List but not in Program
Posted: Fri Nov 16, 2018 2:30 pm
by S3D-Jake
Thanks for all your reports, everyone! Is everyone searching for their printer on the
compatibility checker? It asks that you contact us through our contact us page if your printer isn't listed in the configuration assistant. At that point our team will be happy to assist you with your printer's profile.