how to set new step/unit for ffcp
Posted: Sun Nov 11, 2018 5:10 am
hi from france, i have an ffcp
actually i print with simplify3d, with step multiplier 1.42 for extruder
but for the jog mode, that not work, if i ask 100mm, i push only 70mm
where writer the good step per unit in the firmware for ffcp?
actually i print with simplify3d, with step multiplier 1.42 for extruder
but for the jog mode, that not work, if i ask 100mm, i push only 70mm
where writer the good step per unit in the firmware for ffcp?