Simplify3D User Forum

Posted: **Sun Nov 18, 2018 4:31 pm**

When I change the External Thin Wall Type to "Allow Single Extrusion Walls", parts of the model go missing. See below:

External Thin Wall Type = Allow Single Extrusion Walls:

External Thin Wall Type = Perimeters only:

Factory file:
https://www.dropbox.com/s/4pgn36kkl0mp0 ... ue.factory

What's going on?

Posted: **Sun Nov 18, 2018 6:39 pm**

Looks like you might have found a bug in the code changes for single extrusion processing that has been there since its introduction in v4.0.0.

I've tested on all three v4+ releases and its the same on all three.

Simplify3D User Forum

Allow Single Extrusion Walls causing Parts of Benchy's anchor hole frame to go missing

Allow Single Extrusion Walls causing Parts of Benchy's anchor hole frame to go missing

Re: Allow Single Extrusion Walls causing Parts of Benchy's anchor hole frame to go missing