Simplify3D User Forum

I have just downloaded Simplify3D that I use on our companies custom built machines to print parts. I made the stupid mistake of upgrading without checking the feedback. I am now having many issues with the prints not working properly. Is there any way I can revert back to an older version of simplify.

The biggest problem is avoiding crossing outlines issue, no matter what I do the part will cross outline the same file with the same settings did not do this in a earlier version of the software.

Hello,

Your previous version is still in your computer. The new installation is not removing it. The only problem is when you want a previous version you never had. It's not available anymore as soon the new one is released, wich is a very bad move IMO.