impossible to start with simplify 3d
Posted: Wed Dec 12, 2018 2:24 am
hi a friend share me his licence for test simplify 3d with my custom flash forge creator pro
the head is multiplier by 5
my problem is where write the new step per unit in the firmware? if i want move manually each extruder to 10cm, i have only few cm on the reality output
in fact i can t use really simplify 3d, and mean i can t buy my licence, because my friend share it only few week for test
the head is multiplier by 5
my problem is where write the new step per unit in the firmware? if i want move manually each extruder to 10cm, i have only few cm on the reality output
in fact i can t use really simplify 3d, and mean i can t buy my licence, because my friend share it only few week for test