Partial higher Infill?
Posted: Fri Jun 27, 2014 5:29 am
Hello!
It is possible to strengthen areas in the model with a higer infill?
I want to print fast (low infill) but at some locations I want to print a high infill.
E.g. a hole with more shells than the rest of the model.
Or on areas, where higher forces will touch the surface I want to print pillars in the model.
regards
Ovu
It is possible to strengthen areas in the model with a higer infill?
I want to print fast (low infill) but at some locations I want to print a high infill.
E.g. a hole with more shells than the rest of the model.
Or on areas, where higher forces will touch the surface I want to print pillars in the model.
regards
Ovu