Page 1 of 1
[SOLVED] 4.1.1 Bridge Infill Angle Fail
Posted: Mon Dec 17, 2018 6:46 pm
by fffolly
S3D 4.1.1 ignores the bridging infill angle settings - always at zero degrees whether "Fixed" is checked or not or set at any other angle. this feature worked correctly in 4.1.0.
Re: 4.1.1 Bridge Infill Angle Fail
Posted: Tue Dec 18, 2018 12:46 pm
by S3D-Alex
Can you please post a Factory File showing this issue?
Re: 4.1.1 Bridge Infill Angle Fail
Posted: Wed Dec 19, 2018 2:04 pm
by fffolly
Oops! I was wrong it does work as advertised. Sorry.
Re: 4.1.1 Bridge Infill Angle Fail
Posted: Wed Dec 19, 2018 2:06 pm
by dkightley
