Simplify3D User Forum

Hi I just opened up S3D and did most if not all of the tutorials and know how to use the product pretty well now.....

I have some simple questions as I progress from makerware and proftweak to S3D.

1) Overlap - what are people typically using?
2) Build Platform temp - how do you simply tell the software to keep it at 40 deg forever?
3) Multiplier PLA vs ABS - What is the most common mult for PLA and ABS? Don't worry I will adjust mine I'm just looking where to start.
4) Cool - I'm lost here any suggestions what to do other than the defaults?


Thanks all much appreciated.