Have speed overrides not apply to additions (prime pillar, ooze shield, etc)
Posted: Fri Jan 04, 2019 12:37 pm
I,
I am using simplify3D 4.1.1.
if you use a primary tower, the speed reduction also applies to the tower.
Thus a small print lasts 10 hours instead of three.
This is an STL to reproduce the behavior.
https://www.thingiverse.com/thing:729822
Best
I am using simplify3D 4.1.1.
if you use a primary tower, the speed reduction also applies to the tower.
Thus a small print lasts 10 hours instead of three.
This is an STL to reproduce the behavior.
https://www.thingiverse.com/thing:729822
Best