Simplify3D User Forum

Posted: **Sat Jan 26, 2019 11:50 am**

This is an easy one:
If I want to divide my print into parts for changing the material (color), I use "Start/Stop printing at height" in the Advanced Settings.
To find out the right layer, I use the Preview Mode. There, only layer numbers are visible, not height.
So it would make sense, if I could use the layer number I found for the "Start/Stop printing at height" setting and not only a height in mm.
It's a "nice to have" ...
Thanks!

Posted: **Wed Jan 30, 2019 4:49 pm**

Thanks for your request. This is actually a duplicate of an existing feature request thread. viewtopic.php?t=8311

Posted: **Thu Jan 31, 2019 7:02 am**

Raur wrote: ↑Sat Jan 26, 2019 11:50 am This is an easy one:
If I want to divide my print into parts for changing the material (color), I use "Start/Stop printing at height" in the Advanced Settings.
To find out the right layer, I use the Preview Mode. There, only layer numbers are visible, not height.
So it would make sense, if I could use the layer number I found for the "Start/Stop printing at height" setting and not only a height in mm.
It's a "nice to have" ...
Thanks!

Heights are at the bottom left of the preview screen/window just above the sliders. Pretty hard to see .

Posted: **Thu Jan 31, 2019 7:21 am**

Thanks for the hint. In fact I overlooked these numbers.

Simplify3D User Forum

Specify layer numbers at "Start/Stop printing at height"

Specify layer numbers at "Start/Stop printing at height"

Re: Specify layer numbers at "Start/Stop printing at height"

Re: Specify layer numbers at "Start/Stop printing at height"

Re: Specify layer numbers at "Start/Stop printing at height"