Simplify3D User Forum

Posted: **Sun Feb 03, 2019 11:39 am**

I have an OpenSCAD STL design that is composed of two halves. I would like to have them separate so I can place filament change code in the top half. I do not see any way of doing this in S3D. Any other ideas?

Thanks,

Jerold

Lucy.stl: (1.04 MiB) Downloaded 159 times

Posted: **Wed Feb 06, 2019 1:43 am**

Mesh > Separate Connected Surfaces

Simplify3D User Forum

STL File Split Into Two Parts

STL File Split Into Two Parts

Re: STL File Split Into Two Parts