Simplify3D User Forum

First, sorry for my bad English, I'm French. For some time, I have this problem and I do not know what it is.
There are irregularities in the first layers. I have Anet A8 and I print with PLA (Sunlu).
Here are some photos.
Thank you in advance for your help.

Sébastien

What temperature is your extruder set to?

This looks like you might be printing too close to your build surface. I would suggest re-leveling your bed or using a positive G-code offset of ~.05 in the Z direction. This setting is found in the Gcode tab under the Global Gcode Offsets heading.