Simplify3D User Forum

Posted: **Sat Mar 02, 2019 3:36 pm**

I'm trying to print this helmet from Thingiverse - https://www.thingiverse.com/thing:2886729

But as you can see from the pics, when I slice it S3D is adding some odd triangles inside the helmet. Any ideas?

Thanks
Nathan

Posted: **Sat Mar 02, 2019 5:04 pm**

Very nice but faulty ...

horst.w
GER

Posted: **Sat Mar 02, 2019 5:18 pm**

Thanks - I'm currently trying to print as is and will remove the bad bits (have a fancy dress party next week). I'm also trying to run through various repair tools.

Posted: **Sat Mar 02, 2019 6:06 pm**

fyI Mesh mixer cleaned the worst of it up.
Thanks Again
Nathan

Simplify3D User Forum

Slicing - S3D adding Triangles in Void when sliced

Slicing - S3D adding Triangles in Void when sliced

Re: Slicing - S3D adding Triangles in Void when sliced

Re: Slicing - S3D adding Triangles in Void when sliced

Re: Slicing - S3D adding Triangles in Void when sliced