Has anyone else had this issue?
E3D documentation on the cyclops warns against any more than 2mm retraction, so that's where I'm at.
Tried z-lift. Coasting at the end seems to help a little. Only retract open spaces is disabled.
Thanks so much
Keeps printing travel moves between part and prime tower.
Using E3D Cyclops dual print single nozzle setup. Attached print preview, results pic and factory file.
Has anyone else had this issue?
E3D documentation on the cyclops warns against any more than 2mm retraction, so that's where I'm at.
Tried z-lift. Coasting at the end seems to help a little. Only retract open spaces is disabled.
Thanks so much
Has anyone else had this issue?
E3D documentation on the cyclops warns against any more than 2mm retraction, so that's where I'm at.
Tried z-lift. Coasting at the end seems to help a little. Only retract open spaces is disabled.
Thanks so much
- Attachments
-
