Page 1 of 1
Print getting inverted when sliced??????
Posted: Fri Mar 15, 2019 10:50 pm
by Rewire
Can someone tell me what is going on?
All my prints are doing this when they get sliced all of a sudden.
Re: Print getting inverted when sliced??????
Posted: Tue Mar 19, 2019 2:48 pm
by S3D-Jake
Have you tried any of the solutions mentioned in our common mesh errors article?
https://www.simplify3d.com/support/arti ... sh-errors/
Re: Print getting inverted when sliced??????
Posted: Wed Mar 20, 2019 9:42 pm
by MicroVoxel
Could it be the “Merge all outlines into a solid model” option under the advanced tab?
Re: Print getting inverted when sliced??????
Posted: Thu Mar 21, 2019 6:59 am
by wirlybird
Maybe supply a factory file so we can take a look and see if it can be reproduced?