Simplify3D User Forum

Problems with the management of the first layer continue to persist.
The width of the extrusion of the first layer cannot be varied, this means that those who use the raft do not adhere well.

It is a regression that persists from 4.1.0

After updating yesterday I also have problems with this change in settings. Do you already have found a solution?

Duplicate threads doesn't mean the issue will get fixed twice as quick!

viewtopic.php?f=9&t=13075

It was a conscious change to address some unknown issue that has consequences with existing profile setup! Not a good practise...particularly when the effect is not documented in the release notes!

Not the first time it has happened....and no doubt not the last either!