Award-Winning Support Structures???
Posted: Sat Apr 06, 2019 7:53 pm
Please explain how this is an award winning support structure.
No supports over a 120mm bridge?
Then I tried to print a model with 1/16th inch holes, with a 0.2mm nozzle. It shouldn't have been a problem, but...
So I decided to download Cura. It didn't cost me 150. It was free. Can you spot any differences?
I don't mind paying for software when it's beneficial to my workflow, as you can see from the Fusion 360 link in the taskbar, but when I pay for software, I expect it to perform at least as well as the free alternatives. (both of the examples above were sliced on recommended settings in their respective software).
No supports over a 120mm bridge?
Then I tried to print a model with 1/16th inch holes, with a 0.2mm nozzle. It shouldn't have been a problem, but...
So I decided to download Cura. It didn't cost me 150. It was free. Can you spot any differences?
I don't mind paying for software when it's beneficial to my workflow, as you can see from the Fusion 360 link in the taskbar, but when I pay for software, I expect it to perform at least as well as the free alternatives. (both of the examples above were sliced on recommended settings in their respective software).