Bed not heating with Octoprint/BLTouch/Marlin 1.1.9
I am using Simplify 3D with Octoprint, BLTouch, & Marlin 1.1.9 on a CR-10 S5. After slicing, I upload the file via the Octoprint web interface. Once there, I select the file and 'Print' I can see in Octoprint that the temp moves to 60 (for the bed), but the control box does not register any change in temperature, nor does it appear that the bed is heating up. Are there any settings that I could be missing in S3D that would cause the bed to not heat?
