Simplify3D User Forum

I am having problems printing on my FlashForge Adventurer 3 with Simplify3d

I can only print at half the build size in the X & Y axis, but the full amount in the Z Axis.

I can print larger models using flashprint (the propriety slicer) .

for large models the printer complains that there is a file-format issue, and wont start printing.

Does anyone have any ideas what could be wrong?

Thanks Andrew

What version of S3D?

I am having the same issue. Any solution? 4.1.0 and 4.1.2

You can email support for an updated profile.