terry1956
Posts: 8
Joined: Tue Mar 28, 2017 1:48 pm

Settings for TPU

Tue Apr 16, 2019 4:33 am

Hi, what are people finding the best settings for printing TPU. At the moment I have the speed at 25mm as any higher the filament just sticks in the gears. The print is so slow it’s just silly. Is there a better way. The printer is an ender 3.

airscapes
Posts: 256
Joined: Tue Mar 06, 2018 10:35 am
Location: Philadelphia PA Area

Re: Settings for TPU

Tue Apr 16, 2019 5:58 am

No, unfortunately slow is the word of the day. These are my notes on the settings that work for me on my direct drive machine

Ninjafles 0.5 Auto .6 92-3 0.173 225/40 No Retraction if you can get away with it Speed 6mmS

So .5 nozzle extrusion width auto (.6), extrusion multiplier .92-93, Filament diameter 1.73 (or actual measured) nozzle temp 225 bed 40, retraction off or if on, .3-.5 mm at a speed of 6mmS

Print speed depends on the model but bettween 10 and 15mmS . Much slower than 10 and the plastic leaks out of the nozzle faster than it is moving and creates voids too fast and you get drive issues.
Drive tension on my machine is just a screw that pushed the bearing against the drive with no spring. It is crucial to get this "JUST" right too loose and it slips, too tight and the filament gets squished and will not move forward.. Once I found the right spot, that setting has worked fine for all other filaments thus far. I only use it for things like rubber bands, vibration dampers, gaskets etc.. so very simple shapes.. and small sizes..
Good luck

S3D-Chris
Posts: 109
Joined: Wed Jun 20, 2018 11:52 am

Re: Settings for TPU

Wed Apr 17, 2019 9:18 am

Check out our Materials Guide Flexible filament article for TPU settings: https://www.simplify3d.com/support/mate ... /flexible/

airscapes
Posts: 256
Joined: Tue Mar 06, 2018 10:35 am
Location: Philadelphia PA Area

Re: Settings for TPU

Wed Apr 17, 2019 1:58 pm

Forgot to say, a gravity feed spool set up is almost 100% required unless you want to hand feed it..
Gavity Feed small.jpg

Return to “General Discussion and Tips”