ilium007
Posts: 1
Joined: Wed May 15, 2019 7:15 pm

Z axis crashing into bed when printing via USB

Wed May 15, 2019 7:24 pm

I have a strange issue whereby if I stop a print using the "Machine Control Panel", make some changes and then click print again, instead of the machine executing a G28 which is in my start gcode, the Z axis moves in the other direction and I have to power it off before it hits the bed. If I turn the machine off and on and click print again it goes about its usual G28 and homes the axis.

Return to “Troubleshooting and Bug Reports”