OrionDragon
Posts: 1
Joined: Wed Jun 12, 2019 2:28 am

Blobs or Zits on layer change

Wed Jun 12, 2019 2:42 am

Hi,

I have been at this for a few days now and cannot get rid of the layer change zits or blobs.
I am using Simplyfy3d and have tried all sorts of combinations.
has anyone got any suggestions for me?
Attachments
20190612_083210.jpg

TheBum
Posts: 107
Joined: Fri May 18, 2018 11:13 pm

Re: Blobs or Zits on layer change

Wed Jun 12, 2019 3:15 pm

Have you calibrated your extruder? It appears you might have some over-extrusion going on. What happens if you lower the extrusion multiplier? Something else to try if you just want to address the start-of-line blobs is to specify a negative restart distance.

Return to “Troubleshooting and Bug Reports”