layer height warning doesn't trigger on first layer
Posted: Fri Jun 28, 2019 12:40 am
With a 0,4mm nozzle set to extrude 0.48mm wide tracks am set to print at 0.4mm layer height.
Did not notice 1st layer height was set to 200% from an earlier print.
Just laid down a 0.8mm first layer. Think it has worked, but there was not warning about the ratio.
Did not notice 1st layer height was set to 200% from an earlier print.
Just laid down a 0.8mm first layer. Think it has worked, but there was not warning about the ratio.