Simplify3D User Forum

Posted: **Wed Aug 13, 2014 8:58 am**

Hello I have a messy layer after the support, see:
https://plus.google.com/photos/yourphot ... 9165800515

Horizontal offset from part: 0.3mm
Up Vertical separation layer: 1
Low Vertical separation layer: 1

Any good idea?
thx

Posted: **Thu Mar 19, 2015 11:44 am**

Hello.

I have the same problem.
Please reply, if anyone has a solution !

Thank you very much!

Posted: **Sat Mar 28, 2015 2:01 am**

I think i have a similar issue.

John

Simplify3D User Forum

first layer after support

first layer after support

Re: first layer after support

Re: first layer after support