Support for M73 - Print Progress Percentage
Posted: Tue Aug 06, 2019 11:58 pm
Since the filament length for a print job is known, why not support M73 - SET PRINT PROGRESS
http://marlinfw.org/docs/gcode/M073.html
Having an integer percentage displayed on the LCD panel of a 3D printer - can help in terms of pre-empting problems like filament run-out
http://marlinfw.org/docs/gcode/M073.html
Having an integer percentage displayed on the LCD panel of a 3D printer - can help in terms of pre-empting problems like filament run-out