Posts: 1
Joined: Mon Aug 12, 2019 5:25 am

X move at start

Mon Aug 12, 2019 5:30 am

At the start of each print, the nozzle moves to X=0,Y=0 and moves in X across the width of the bed. Could this move be eliminated?
My problem is that it hits my glass clamps.

Posts: 90
Joined: Fri May 18, 2018 11:13 pm

Re: X move at start

Mon Aug 12, 2019 11:26 am

Take a look at the Scripts tab in the process configuration. In there, you'll see a tab for ths start script. The offending commands are likely in that script if they're not burned into the firmware.

Return to “Troubleshooting and Bug Reports”