Page 1 of 1
dimensional accuracy
Posted: Tue Aug 26, 2014 10:58 am
by soa
I have printed the same 110mm x 110mm square part using S3D and MakerWare on my MB Rep2. The MW printed part was undersized by 0.15mm (good-ish) and the S3D part was oversized by 6.7mm (way bad). What can I tune to reign in this discrepancy?
Re: dimensional accuracy
Posted: Thu Aug 28, 2014 9:30 am
by chath
you can adjust the steps in a startup script on the scripts tab. i forget the gcode but it's a one liner
Re: dimensional accuracy
Posted: Thu Aug 28, 2014 9:53 am
by soa
6% off seems like a big default discrepancy. are others seeing this or is it unique to my setup? thanks.