Page 1 of 1
infill gap
Posted: Tue Sep 03, 2019 5:24 am
by PaV
what is the reason for this gap ?
in my case, I print a cylinder and every layer gets this gap
Thank you
Re: infill gap
Posted: Tue Sep 03, 2019 8:35 am
by dkightley
Can you please post the factory file for the above cylinder. File Menu>>>>Save Factory File as
Without seeing exactly where your settings are, its almost impossible to give a sensible answer....
Re: infill gap
Posted: Tue Sep 03, 2019 9:57 am
by PaV
dkightley wrote: ↑Tue Sep 03, 2019 8:35 am
Can you please post the factory file for the above cylinder. File Menu>>>>Save Factory File as
Without seeing exactly where your settings are, its almost impossible to give a sensible answer....
please
Re: infill gap
Posted: Tue Sep 03, 2019 11:24 am
by dkightley
To fine tune the settings to get a good print for this particular shape file, all I needed to do was to change the infill type to "Grid" and the Outline overlap to "11%"