Posts: 9
Joined: Mon Nov 05, 2018 9:15 am

Applying smaller layer height for flat areas automatically?

Mon Sep 09, 2019 1:51 pm

Some models might have certain flat areas at different heights. A smaller layer height might help improve the printing quality of these flat areas, but would increase the total needed printing time significantly.

I know that several processes with different layer heights can be used for printing the single part. But as shown in the example attached, the manul work for breaking up the part vertically would be very time-consuming.

I wonder whether there is certain trick to accomplish the job - applying smaller layer height for flat areas - automatically. Thank you for your suggestions!
(1.78 MiB) Downloaded 24 times

Return to “Feature Requests”