tobyCwood
Posts: 43
Joined: Sat May 11, 2013 1:59 pm

Is there documentation for the start script gcode????

Sat Oct 05, 2019 7:17 pm

I am trying painfully to write start gcode for a four extruder system. Single extruder start code contains extruder references that get used to insert the temps entered into the S3D UI into the gcode... (i.e.,extruder0_temperature]. Doing an "extruder3_temperature" DOES NOT WORK.
Can someone PLEASE tell me where this stuff is documented for Simplify3D?????

S3D-Chris
Posts: 155
Joined: Wed Jun 20, 2018 12:52 pm

Re: Is there documentation for the start script gcode????

Tue Oct 08, 2019 9:46 am

Check out this Tip of the Day post: viewtopic.php?t=1959

Return to “General Discussion and Tips”