Page 1 of 1
Lulzbot Mini with optional noozle
Posted: Sun Oct 27, 2019 6:59 pm
by jaybeckham
I have upgraded by Mini to the SL nozzle which is 0.25mm rather than the original
0.50mm one. Where in this software to I indicate my new SL nozzle?
Thanks!
Jay Beckham
Re: Lulzbot Mini with optional noozle
Posted: Mon Oct 28, 2019 1:43 pm
by S3D-Chris
You will need to update the Nozzle Diameter option in the Extruder tab of your Process Settings.
Re: Lulzbot Mini with optional noozle
Posted: Mon Oct 28, 2019 3:52 pm
by jaybeckham
Thanks for the information. I will work on that. Now if I could just get S3D to connect with my Lulzbot. It uses Com 4 and S3D did and couldn't connect. May have to call the help desk I guess.
Jay Beckham
Re: Lulzbot Mini with optional noozle
Posted: Fri Nov 01, 2019 8:08 am
by S3D-Alex
We have an FAQ entry with some suggestions that may help so I have included a link to that below. If those steps do not work could you please post a screenshot of the communication log in Simplify3D when you try and connect to your machine?
https://www.simplify3d.com/support/faq/#quest-6354