Simplify3D User Forum

Hi,

I'm looking to buy the Snapmaker 2.0 version A350, but I would like to know if the S3D will be compatible?
Actually seem that the Snapmaker 1.0 is working.

Jean-Guy

I use a profile for my Snapmaker 1.0 that I fully expect to work with the A350 after adjusting the bed size. I'm not sure about being able to print directly from S3D: I actually use an OctoPi as a network interface for my Snapmaker and just upload the G-code files to it and print from there. If the A350 supports raw sockets on its network interface, I would expect S3D to be able to print directly, but I'll still likely upload files to it so that I'm not reliant on the network connection to finish the job.

deltasigma wrote: ↑Thu Nov 21, 2019 3:11 pm Hi,

I'm looking to buy the Snapmaker 2.0 version A350, but I would like to know if the S3D will be compatible?
Actually seem that the Snapmaker 1.0 is working.

Jean-Guy

Please contact our support team at [email protected] and we will help you with a profile.

Thanks for the information.

Will this be available soon?
I have a A250 and the Snapmaker software is awful!
Many people are receiving their Snapmaker 2.0 now, so a lot of people will want this

I have my SM2 A350 and would love to have a Simplify3D profile for it, I do not much care for theirs and I honestly have only used simplify3d for ages now!

HI did you manage to get a profile for Snapmaker 2 A350

Where can we find the complete profile for snapmaker 2 different model (A350)?

I'm also looking for a profile for the 350.