Posts: 5
Joined: Mon Jul 08, 2019 4:05 pm

Ender 5 with TH3D firmware and Silent Board

Sun Dec 01, 2019 10:23 am

Just an FYI, I have not tested this yet. For those upgrading to the "Silent" board for your Ender 5 and using TH3D firmware, you'll notice the axis are flipped. Not exactly sure the cause but I think Simplify3d should have a profile for the Ender 5 with Silent Board. I think the Homing Direction under G-Code needs to be set to Max instead of Min, again not sure yet as I had to put my old board back in to get some prints finished. ... ackwards/3

Return to “Troubleshooting and Bug Reports”